Motorcycle chain is an important part of your bike, no chains then your motor can not be used to make a chain motors must often get routine maintenance and checks.
Because of the damage to the chain of your bike can harm you while you travel such as slippage, concerns, and even separated from the gear chain, these events usually occur due to the chain that had gotten loose, too tight, less oil or rusty.
Here are tips for caring for your motorcycle chain for durability.
1. Set the chain regularly
Adjustment is not simply tighten or loosen the chain, but also set the lock pin connection and remove any dirt or dust off.
It is advisable to have a chain adjustment each motor has run 1,000 kilometer.Tingkat chain tension should be in the position of 5-25 millimeters. To determine the size it was in the mall or line the existing standards in the towing chain at the lower end shockbreaker rear wheels.
2. Make sure the motorcycle chain lube is always given on a regular basis
Chain motor dry and dirty conditions are potentially lead to displacement layer gear quickly and result in gear faster. The use of a motor chain lubricants are required to reduce the friction, as well as to eliminate the annoying sound of friction that usually arises when the chain in dry conditions and dirty.
Usually, some people use chain lube to clean the dirt on the chain and gears, is quite an effective way for hygiene chain. Meanwhile, some others use engine oil that is believed to be better in the awetnya lubricants, because it does not require to be applied repeatedly to the chain as well as chain lube.
However, to use the engine oil is recommended to use the new engine oil, because net of iron content, unlike the used oil that is usually already contained "growled" (iron residual motorcycle engine wear) and can even erode the surface of the gear and chain faster.
3. Set the attenuation rate is fitting chain
Chain is too tense / tight nor too loose / dangling also have adverse implications for the chain and gear.
If the chain is too tight, it can result in broken chain, and if the chain is too loose can result in loss of the chain from gear as well as enabling terlilitnya tire chains on a drum which is fatal.
It is advised to determine tinggat estrangement with the chain on the chain swing distance difference of about 0,5cm-1cm position.
Distance swing existing chain will help the chain to more easily fitting on gear, so the chain can automatically adjust movements.
4. Position the front and rear gear parallel
The layout of the front gear and a rear gear less parallel can affect the use of motorcycle chain. Application gear on the motor is required to stick perfectly and reconciled bosh (rubber vibration dampers) as appropriate in order to track the chain gear can be good at work.
With the straight position between the gear, it is so helps the chain to move right on track, so that its useful life can be
durable.
The addition of iron bosh pasa iron axle (axles) can be used as one way to align the position of second gear.
5. Refine the turn transmission
It is associated with the driving style of each individual, but in spite of differences, it is advisable to refine the transmission shift during acceleration in order to reduce buffeting that occurs in the chain and gear.
With the transfer process smooth transmission, means also reduces the pressure received by the gear and chain. Although considered reasonable because of the process that occurs normal existence, but it also teaches us how to drive professionally.
This method can be used on condition that the clutch function is normal condition, so we can optimize the relationship between the two parts of the motor.
6. The use of original spare parts and qualified
To use the original spareparr and qualified not only for the chain but all parts of your vehicle.
To obtain user satisfaction is required to use the manufacturer's spare parts which are made in accordance in accordance with the bike.
But that does not mean kw or imitation goods can not be used to the maximum. Various methods are used to obtain quality spare parts at minimal costs.
By purchasing a separate gear sets, or provide an additional layer of steel (steel plating) on the gear that we can get from the blacksmith two things intended to allow the ability able to match the quality of the goods imitation original goods.
No comments:
Post a Comment